Installation of C125-NINO-MMN Control Unit (Plug & Play)

DANGER:

By law, only authorized electricians are allowed to install the Control Unit.

Make sure that the power to the stove is disconnected before and during the entire installation.

Do not switch on the power from the electrical panel before you have made sure that the Sensor Unit and the Control Unit are set and ready for a function test.

  1. Switch off power to the stove from the electrical panel.
  2. Remove the stove plug from stove wall socket.
  3. Remove the protective film from the adhesive tape and position the Control Unit close to the wall with the socket facing left.
  4. Firmly press and hold the Control Unit against the wall for one minute to make sure that it is properly attached to the wall.
    Note:
    You can attach the Control Unit to the wall with four M4 screws.
  5. Connect the stove power plug to the Control Unit socket and connect the Control Unit power plug to the wall socket.
    Note:
    Make sure that the plug is properly plugged in.